簡單伺服測試儀電路--Simple Servo Tester
click here to download schematic in pdf
This is a simple servo tester which will comprehensively test the capabilities of almost any modern servo. It has two pushbuttons, CENTRE and SWEEP and a potentiometer which works as follows:
- CENTRE Does exactly that, centers the servo, afterwards the potentiometer determines position.
- SWEEP Sweeps the servo back and forth at a rate determined by the potentiometer setting.
The PIC uses its internal timer to set up a constant frame duration of 20ms and the on/off ratio is set by the user.
Have Fun
ed
PCB board (download it below)
suggested panel decal
Parts List
R1 = 1K
R2 = 10K
R3 = 82R
R4 = 10K
R5 = 5K potentiometer
C1 = 27pF
C2 = 27pF
C3 = 100nF
D1 = 4,7V zener diode
Q1 = 10MHz crytal
IC1 = PIC12F675
當電路中的信號發生突變(特別是數字信號)時,信號經常會出現一個電噪聲。這個噪聲在一般環境下不會對外產生影響。但是在某些特殊情況下,該信號會對外產生較強的傳導干擾,進而影響其他電路的正常工作
關鍵字: 電路 數字信號 噪聲當汽車進行轉彎時,司機打開轉向燈,尾燈會根據轉向依次被點亮,經過一定的間隔后,再全部被消滅。最后不停地重復,直到司機關閉轉向燈。
關鍵字: 汽車尾燈 電路 轉向燈